Grizzly Switch H8246 User Manual

modEl h8246

WidE singlE mini

on/off sWitCh

instrUCtions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com

to reduce risk of serious burns, electrocu-

tion or death when installing this switch:

• only use this switch to replace an exist-

ing component switch that has the same

physical configuration and equivalent

electrical specifications/ratings.

figure 1. Model h8246.

• Installation must only be performed by an

introduction

the Model h8246 features a wide single on/oFF

toggle switch and fits into a ⁄4" x ⁄8" rectangular

hole.

electrician or qualified service personnel,

and all applicable electrical codes must

be adhered to.

• Turn off and completely disconnect all

power sources to the component before

installing the switch.

specifications

rated Voltage.....................................125V/250V

rated Current..................................................6A

• Only install this switch on the "hot" wires.

do not install it on the neutral or ground

wires. otherwise, the component could

still be receiving live current even when

the switch is turned OFF.

• Do not use this switch in wet or damp

locations, or near explosive fumes or

flammable liquids. it is not sealed or rated

for these environments.

• Make sure there is a verified compo-

nent ground on the circuit this switch is

installed.

Warning: no portion of this instrUCtion shEEt may bE rEprodUCEd in any shapE

or form WithoUt thE WrittEn approval of grizzly indUstrial, inC.

#ts13926 printed in ChinA