Havis Shields Network Card C TCB MAK User Manual

INSTALL INSTRUCTIONS C-TCB-MAK

MONITOR ADAPTER KIT

FOR USE ON ALL STRAIGHT POLED C-TCB’S

TOOLS REQUIRED:

Ratcheting wrench

T-20 torx bit

Sockets - 7/16”, ½”

3/16” Allen key

Combination wrenches - 7/16”, ½”

HARDWARE:

ITEM #

QTY

DESCRIPTION

PART #

Rotating TCB plate

Bolt/nut weldment

5/16-24 Flex nut

5/16-24 x 1” Socket head cap screw

5/16” Belleville stainless washer

5/16” x 2” Fender washer

5/16-24 Hex jam nut

CM93073-2

CM001491

CM86209

CM86502

GSM31092

GSM31020

GSM30070

GSM30017

5/16-18 nylock nut

Always!

ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.

ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

ꢀ Use hardware provided with install kit

#5, 8

#3, 4, 5, 6, 7

Straight inner

pole assembly