INSTALLATION INSTRUCTIONS FOR
HUNTER CEILING FAN LIGHT KIT
FLUSH MOUNT STYLE
READ AND SAVE THESE INSTRUCTIONS
CAUTION:
1. Read entire instructions carefully before beginning installation.
2. To avoid possible shock, be certain electricity is shut OFF at
main panel before wiring.
Fan Switch Housing
3. All wiring must be in accordance with national and local elec-
trical code.
4. Professional installation recommended.
FIGURE 4
Pre In st a lla t io n Pre p a ra t io n
Light Kit
Unscrew the decorative finial on the light kit by turning it counter
clockwise. Slide it off over the pull cord, removing the keeper on
the end of the cord only if necessary. Remove the light kit cover
plate. See Figure 1.
FIGURE 1
Screws
Decorative Finial
Feed the pull cord back through the light kit cover and the decora-
tive finial. Center the light kit cover on the threaded nipple, mak-
ing sure no wires are caught or in the way. Thread the decorative
finial onto the threaded nipple and hand tighten. Re-install the
cord keeper if it was removed previously.
Light Kit Cover Plate
Pull Cord
Remove the cover plate from the fan switch housing.
In st a llin g Glo b e s a n d Bu lb s
Place globe over threaded lampholder in cup. Install and hand
tighten threaded locking ring on lampholder as shown in figures 5
and 6
Note: Do not discard the switch housing cover plate. You will
need to replace it if you remove the light fixture in the future.
Wire t h e Lig h t Kit
CAUTION: This appliance must be earthed.
Install bulbs. Use E-27 bulb, no smaller than A-19 (60mm diam-
eter). Turn power ON at main panel.
Locate the two wires in the fan switch housing that have connectors
attached. Pull the plugs out of both connectors. Connect the black
and white wire to the brown wire of the light kit. Connect the blue
wire to the blue wire of the light kit. Be sure to connect the green
Cup
FIGURE 5
Threaded
and yellow ground wire to the screw marked
base of the switch housing. See Figure 2.
located at the
Lamp
Holder
Co m p le t e t h e Asse m b ly
Attach the light kit to the fan switch housing using the screws
provided, leaving screws slightly loose temporarily. Make sure all
wires fit flush inside the switch housing. See Figures 3 and 4 .
Threaded
Locking Ring
Globe
Rotate the light kit counter clockwise as seen from below, until it
stops, so the screws are lined up in the narrow notches in the mount-
ing holes. See Figure 3 Tighten the screws securely.
Note: As shown in Figure 6, line up the beginning of the first
thread on the lamp holder and notch on the locking ring to
avoid cross threading the ring. If ring becomes hard to turn,
rotate ring counter clockwise to loosen and reposition. Do
not force the ring on.
FAN SWITCH
HOUSING
GROUND
SCREW
FIGURE 6
Beginning of
First Thread
Threaded
Locking Ring
FIGURE 2
Notch in Ring
HUNTER FAN COMPANY
2500 FRISCO AVENUE
MEMPHIS, TN 38114
FIGURE 3
41449-01 05/00
©2000 HUNTER FAN CO
|