Instructions for Installation and Use
Barbecue
Model E3BX
Introduction
Your new 'barbecue' is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has
been installed in accordance with the installation instructions detailed in this booklet.
To help make best use of your cooking equipment, please read this booklet carefully.
The appliance is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.
To obtain the best results, we recommend pre-heating the lava rock for at least 10 minutes on setting 1.
This is particularly advisable when you turn on the appliance for the first time, because it allows you to reduce the risk,
during cooking, of the food absorbing smells that the heating coil produces when it is first switched on.
* The guarantee is subject to the provisions that the appliance:
(a) Has been used solely in accordance with this booklet.
(b) Has been properly connected to a suitable supply voltage as stated on the rating plate, attached to the
appliance.
(c) Has not been subjected to misuse or accident or been modified or repaired by any person other than the
manufacturers authorised employee or agent.
(d) Has been correctly installed.
This appliance conforms with the following European Economic Community directives
-
-
-
73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications.
89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications.
93/68/EEC of 22/07/93 and subsequent modifications.
3
For Your Safety
When used properly your appliance is completely safe but as with any electrical product there are certain
precautions that must be observed.
PLEASE READ THE BELOW PRECAUTIONS BEFORE USING YOUR APPLIANCE.
To maintain the efficiency and safety of this appliance, we recommend you do the following:
- only call the Service Centres authorised by the manufacturer.
- always use genuine spare parts.
ALWAYS:
NEVER:
- make sure you remove all packaging and dispose of safely.
- check the soundness of the appliance after it has been
unpacked.
- make sure you understand the controls before using the
appliance.
- keep children away from the appliance during use.
- take care to avoid heat/steam burns when operating the
control.
- attempt to install or repair the appliance without the
assistance of qualified personnel.
- store items above the appliance that children may attempt
to reach.
- heat up unopened food containers, as pressure can build
up causing the container to burst.
- use the appliance to heat up anything other than food.
- use the appliance as a room heater.
- make sure the control is turned off when you have finished
cooking and when not in use.
- disconnect from the power supply, and allow to cool, before
cleaning or performing maintenance.
- refer servicing to a qualified appliance service engineer.
- keep the appliance clean as a build up of grease or fat
from cooking can cause a fire.
- follow the basic principles of food handling and hygiene to
prevent the possibility of bacterial growth.
- dry food thoroughly before cooking and lower it slowly into
the hot oil or fat. Frozen food in particular, will cause froth
and spitting if added too quickly.
- dry any items on the appliance.
- install the appliance next to curtains or other soft furnishings.
- allow children to play with or tamper with the control.
- leave children unsupervised where cooking appliances are
installed as all the cooking surfaces get hot during and after
use.
- store chemicals, foodstuffs or pressurised containers in or
on the appliance, or in cabinets immediately above or next
to the appliance.
- use flammable or plastic items on or near the appliance.
- use adapters, multiple sockets and/or extension leads.
- fry too much food at a time, especially frozen food. This
only lowers the temperature or the oil or fat too much, resulting
in greasy food.
- keep any ventilation slots clear of obstructions.
- pull on the appliance or the supply cable to unplug it from
the electrical outlet.
- allow power cables of other appliances to come into contact
with hot parts of this appliance.
- expose the appliance to atmospheric agents, such as
rain or sunlight.
- operate the appliance with wet hands.
- operate the appliance when barefoot.
- allow anyone to sit or stand on any part of the appliance.
- leave anything on the surface when unattended and not in
use.
4
Know your Barbecue
A
A
C
Control knob
How To Use Your Barbecue
The barbecue allows you to grill your food fast.
Using the control knob on the front panel you can set
the heat output from very low (1) to high (10) and to grill
(11).
When turning to 11 you will hear a click that shows that
the thermostat has been turned off and the heating coil
soon gets red hot.
The intermediate positions are recommended for cooking
delicate dishes or to cook the food evenly overall, and right
into the middle as well.
The lava rock in the tray is provided to absorb the drips of
oil or grease that are produced during cooking. It also
stores heat during the start up phase of the heater to give
you a more constant grilling performance, which is very
similar to that obtained from charcoal.
Water can be put into the tray, instead of the lava rock
(we recommend a depth of about 3mm or 1 inch). The use
of water in the tray eliminates unpleasant cooking smells,
without reducing the performance of the barbucue.
Return the conrol knob to 0 to turn off.
5
Care and Cleaning
Before cleaning or performing any cleaning or maintenance,
disconnect the appliance from the power supply. Check that
all controls are in the OFF position, '0', before reconnecting.
The steel and/or painted parts must be cleaned using suitable
products which are neither abrasive nor corrosive.
Avoid products based on chlorine (bleach etc.).
Avoid leaving acids or alkalis on the work surface (vinegar,
salt, lemon juice etc.).
NEVER USE: Washing powder, harch abrasive,
scouring pads, aerosol cleaners or oven chemical
clearners of any kind.
Wipe the control knobs with a soft cloth wrung out in warm
soapy water, or mild non-abrasive. Then, after wiping with
a cloth wrung out in clear water, dry with a soft clean cloth.
Troubleshooting
Before calling service for assistance, check through the
following list, there may be nothing wrong.
If, despite all of these checks, the appliance does not function
properly and problem persists, call Hotpoint Service (see
KEY CONTACTS, back page), informing them of:
- The type of problem.
- The abbreviation used to identify the model (Mod. ...) as
indicated on the warranty.
Nothing works.
Check to make sure that:
•
the mains wall switch is switched on.
IMPORTANT:
Poor results.
Never call upon technicians not authorized by the
manufacturer, and refuse to accept spare parts that are not
original.
•
best results are obtained by pre-heating the lava rock
on setting 1, for at least 10 minutes.
6
Installation
These instructions are intended for the qualified technician
installing the appliance in order to insure that the installation,
adjustments and maintenance procedures are performed
correctly and comply with the regulations currently in effect.
Important: the appliance must be disconnected from
the power supply before making any adjustments or
performing any maintenance, etc.
The appliance is Type Y and therefore can be installed
alongside of cabinets which are higher than the surface of
the worktop. The following precautionary measures should
be observed in order to ensure proper installation:
a) Hoods must be installed in compliance with the required
specifications contained in the instruction manual for the
hood itself.
b) The appliance can be installed on any counter top as
long as it is 600 mm or more in width and resistant to
temperatures of up to 100°C. The dimensions and the
position of the hole are shown below.
These measurements must absolutely be observed in
so far as improper installation can cause the surrounding
surface areas to overheat. It is recommended that the
appliance be installed at a distance of at least 55 mm
from the back wall or other vertical surfaces to ensure
that the air circulates properly over the cooking area and
to avoid overheating the surrounding surfaces. A seal or
gasket is provided with the appliance, make sure that it
adheres properly to the bottom part of the appliance
frame. The seal must be fitted properly around the
entire perimeter of the appliance and especially along
the corners in order to create a seal between the
work top and the appliance itself so as to prevent
spills or splashes from leaking into the cabinet below.
The appliance must be fitted into the worktop using the fixing
clamps - see diagram.
Very important
It is essential to install the appliance on a totally flat surface.
Any damage caused by incorrect fitting may alter the
characteristics or impair performance.
Insert the appliance into the hole, pressing firmly around the
frame to make it adhere to the counter top.
Note: If the appliance is installed above a built-in oven, it is
preferable that the oven be installed in such a way that it is
set on two strips of wood; if the oven is installed on a
continuous base, there must be an opening in the back of
at least 45 x 560 mm.
The built-in oven must be equipped with a forced air
cooling system.
7
Electrical Connection
Electrical Connection
Connecting the supply cord to the electrical mains:
THIS APPLIANCE MUST BE EARTHED.
The installation procedure must be carried out by a qualified
electrician.
The electrical safety of this appliance is guaranteed only if
the appliance is correctly earthed in compliance with the
standards of electrical safety.
The appliance must be connected to a double pole mains
switch which must be installed between the appliance and
the mains. The double pole mains switch must have a
minimum of 3mm of space between the contacts, be sized
to the load and comply with current regulations (the switch
must not be able to disconnect the earth conductor).
The manufacturer can under no circumstances be considered
responsible for any damage that might occur due to incorrect
earthing of this appliance.
The supply cord should conform to BS6004 conductor size
4mm and must be positioned so that no part of it reaches
a temperature of 50°C higher than room temperature.
2
Before making the connection, make sure that:
•
•
•
•
the limiter switch (fuse) and the residual wiring can support
the appliance load (see the rating plate).
the mains system is properly earthed in compliance with
current regulations and provisions.
there is easy access to the socket or the double pole
mains switch after the appliance is installed.
the isolation switch must not be positioned directly above
the appliance.
Power supply
Power
230V
2400W
8
Notes
9
After Sales Service
"No company is better positioned to offer an after sales service on a
Hotpoint appliance than us - the manufacturer"
As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts
and labour guarantee for the first 12 months. In addition to this you also have the advantage of free
replacement parts for the first 5 years when fitted by a Hotpoint
engineer. When the 12 months parts and labour guarantee expires we offer the following after sales
service options:
Repair Service and Information Help Desk
UK: 08709 066066
Republic of Ireland: 1850 302 200
Note: Our operators will require the Model number and the Serial number of your appliance
Available 364 days a year with a fast, effective and value for money service. We have the largest white
goods repair service in the UK with over 1200 of our own fully trained engineers. All repairs include a parts
and labour guarantee for 12 months from the date of the repair.
If you require any information or have any questions about your appliance, our operators are on hand with
help and advice.
All this ensures that you will receive the best available after sales service possible.
Extended Warranties
UK: 08709 088 088
Republic of Ireland: 1850 502 200
Whether you have just one or a number of Hotpoint appliances in your kitchen, we offer two service cover
plans to give you total peace of mind.
ꢀ Repair Protection Plan
-
FREE service repairs for a single Hotpoint appliance during the period
of cover.
ꢀ Kitchen Cover
-
FREE service repairs for all your Hotpoint appliances less than 8
years old.
Genuine Parts and AccessoriesUK: 08709 077 077
Republic of Ireland: (01) 842 6836
A wide range of genuine parts and accessories are available from our hotline or through our web site.
Genuine parts and accessories, extended warranties and service repairs are all
available on our web-site at:
GB
10
Guarantee
"Satisfaction guaranteed or your money back"
We give you a unique 'satisfaction guaranteed' promise - valid for 90 days - after you have
purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or
engineer to call. If the technical problem is not resolved under this guarantee, we will replace your
machine or, if you prefer, give you your money back.
All Hotpoint appliances carry a fully inclusive 12 month parts and labour guarantee as well as free
replacement parts for the first 5 years (except microwaves, selected integrated appliances and cooker
hoods, which have a one year guarantee) provided that they are fitted by a Hotpoint engineer.
Guarantee terms and conditions
Your guarantee is only applicable in the United Kingdom or Republic of Ireland and is subject to the
following provisions that your appliance:
ꢀ
ꢀ
Has been installed and used correctly in accordance with this instruction booklet.
Has been used solely for domestic purposes and is located on domestic premises (ie. not for
commercial or trade use).
ꢀ
ꢀ
Has been properly connected to a suitable electrical supply voltage as stated on the appliance
rating plate.
Has not been subject to misuse, accident, modified or repaired by anyone other than one of our
own service engineers.
For pre purchase information on any other Hotpoint product call: 08701 50 60 70
Recycling & Disposal Information
As part of Hotpoint's continued commitment to helping the environment, Hotpoint reserves the right to
use quality recycled components to keep down customer costs and minimise material wastage.
Please dispose of packaging and old appliances carefully.
To minimise risk of injury to children, remove the plug and cut mains cable off flush with the appliance.
Dispose of these parts separately to ensure that the appliance can no longer be plugged into a mains
socket.
GB
11
Key Contacts
After Sales Service
Over 1200 trained specialists, directly employed by us, ensure that you can have complete
confidence in both the appliances and services we offer.
Repair Service and Information Desk
UK: 08709 066 066
(Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays)
Republic of Ireland: 1850 302 200
Note: Our operators will require the following information:
Model number:
Serial number:
Extended Warranties
UK: 08709 088 088
(Open 8 to 8 Mon - Sun)
Republic of Ireland: 1850 502 200
Genuine Parts and Accessories
UK: 08709 077 077
(Open 8-30 to 5-30 Mon - Fri & 9 to 12 Sat)
Republic of Ireland: (01) 842 6836
General Domestic Appliances Limited, Morley Way, Peterborough, PE2 9JB.
February 2003 Part no. FP166 - 01
COD. 1.002.61.0
|