Havis Shields Automobile Parts C TSM CHGR X User Manual

INSTALL INSTRUCTIONS C-TSM-CHGR-X

TRUNK SIDE MOUNT FOR 2006-2008 DODGE CHARGER

X = “D” DRIVERS SIDE OR “P” PASSENGER SIDE

TOOLS REQUIRED:

Ratcheting wrench

Screwdriver set

Utility knife or Jig Saw

Powered drill w/ 1/8” & 3/16” drill bits

HARDWARE:

QTY DESCRIPTION

PART #

10-32 Keps nuts

10-32 x ½” Phillips machine screws

#10 x ¾” Sheet metal screws

GSM30028

GSM33118

GSM33195

Always!

ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.

ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

ꢀ Use hardware provided with install kit

Empty view of passenger

side mounting location

Notch trim as necessary

Note: Vehicles w/ carpeted

fiberglass trim requires more

cutting due to thickness of material,

see next page.

Position trunk side mount and

determine where to notch vehicle trim

in order to function properly

Cut

Pre-drill lower mounting holes

using 1/8” drill bit and attach with

#10 x ¾” Sheet metal screws

Cut carpeted fiberglass trim along

this line for proper fit.

Position Trunk Side Mount and

mark (3) holes on top mounting

bracket